BNF Blade 300 X Instruction Manual download pdf (Page 9)

Rudder

1. Power on the transmitter.

2. Turn TH HOLD ON and put the transmitter into normal mode.

NOTICE: Do not allow the helicopter to move until the Status LED is solid

blue and all menu LEDs are OFF. The gyro will not operate correctly if the

helicopter moves before the Status LED is solid blue.

3. Connect the helicopter battery to the ESC.

4. Move the rudder stick to the right. The tail rotor blades move as shown. If

they do not move as shown, reverse the rudder channel in the transmitter

(refer to your transmitter manual for instructions).

5. Release the rudder control. Manually

turn the helicopter nose to the left.

The tail rotor blades automatically

move as shown. If they do not move

as shown, refer to the AR7200BX

manual for information on reversing

the tail sensor direction (Setup menu

point F).

Cyclic

When using a ﬂ ybarless rotor head, you are controlling rotational rates while

the AR7200BX controls the servos. You are not directly controlling the servos

with the transmitter.

It is normal for the swashplate to slowly move back to its original posi-

tion after a stick input and for the servos to not move at the same speed

as your control sticks.

1. Tilt the helicopter forward. The swashplate should tilt backward.

2. Tilt the helicopter backward. The swashplate should tilt forward.

3. Roll the helicopter left. The swashplate should roll right.

4. Roll the helicopter right. The swashplate should roll left.

5. If the swashplate does not move in the correct direction, you will need to

reverse the cyclic sensor direction. Refer to the AR7200BX manual for

more information (Setup menu point M).

Control Tests

MODE 2 MODE 1

Elevator

Side View

Aileron

Rear ViewRear View

Cyclic and Collective Control Test

Turn on Throttle Hold when doing the control tests

Collective Pitch

Rear ViewRear View

Rudder and Cyclic Gyro Test

CAUTION: You must complete the Rudder and Cyclic tests prior to ﬂ ight. Failure to complete the tests and ensure the sensor directions are not reversed can

cause the helicopter to crash, resulting in property damage and injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Comments to this Manuals

No comments

BNF Blade 300 X Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Toys & accessories BNF Blade 300 X