BNF Focke-Wulf 190A Instruction Manual download pdf (Page 7)

Factory Settings

Horns Arms

Elevator

Rudder

Ailerons

Control Horn and Servo Arm Settings

1. Remove the battery hatch from the fuselage using the latch button.

2. Turn over the fuselage so the bottom faces up and install the wires and

connectors through the hole in the fuselage (A) to the receiver.

CAUTION: DO NOT crush or otherwise damage the wiring when

attaching the wing to the fuselage.

3. Insert the guide pins (B) on the front of the wing in the fuselage plate holes

(C), then connect the wing to the fuselage using 2 screws (D).

4. Turn the aircraft over to connect the servos and optional connectors to

the receiver or Y-harnesses. The left and right servos can be connected to

either side of a Y-harness.

TIP: Carefully coil and store the servo wires in the hole in the fuselage for

easier battery installation.

When needed, disassemble in reverse order.

Wing Installation

More control throw Less control throw

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

After ﬂ ying, you may choose to adjust the linkage positions for the

desired control response. See the table below.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

BNF Focke-Wulf 190A Instruction Manual Page 7